Crushed Concrete Calculator

Cubic yards and tons of recycled crushed concrete for driveways, base and fill.

Area shape
Drawing updates as you type. Not to exact scale.
Cost & options

Enter the area's dimensions to see how much material you need.

This crushed concrete calculator converts an area and depth into the cubic yards and tons of recycled crushed concrete (RCA) you need — a cheaper, greener alternative to virgin crushed stone for driveways, sub-bases and structural fill.

Crushed concrete comes graded like natural aggregate: a dense-graded 3/4-inch-minus for compacted base, and larger clean grades for drainage. It compacts hard; the tool adds a 10% allowance.

Worked example. A driveway base, 50 ft × 14 ft, 5 inches compacted. Area = 700 ft². Order loose depth ≈ 6.5 inches: 700 × 0.54 = 378 ft³ ÷ 27 = 14 cubic yards18.9 tons of recycled crushed concrete. Add 10% → about 20.8 tons, typically 20–40% cheaper than virgin stone.

Where crushed concrete works well

Driveway base and surface, parking pads, shed and slab sub-bases, backfill, and access roads. The fines contain cement dust that re-cements slightly when compacted and wetted, so a 3/4-minus RCA driveway sets up firmer than the same gradation in natural stone.

It is less suited to decorative use — the colour is grey and variable, and you may see rebar-stain rust flecks or bits of asphalt depending on the source.

How deep

Driveway: 4 inches over firm sub-grade for cars, 6 inches for regular truck traffic, compacted in 2-inch lifts. Paver and slab base: 4 inches pedestrian, 6 inches vehicular. One ton covers about 90 square feet at 2 inches compacted.

Buying it

Crushed concrete is sold by the ton and typically runs 20 to 40% cheaper than virgin crushed stone. A cubic yard weighs about 1.35 tons. Ask the supplier whether the material is certified/screened for rebar and contaminants if it is going under a slab. Order 10% over.

Common crushed-concrete mistakes

Assuming it is dirty. Reputable suppliers screen and magnet-separate steel — ask for screened RCA if it goes under a slab or a barefoot area.

Not compacting in lifts. Like any dense-graded base, it needs 2-inch lifts and a little water to bind.

Using it as decorative stone. Colour is grey and variable with the odd asphalt fleck — it is a base material, not a finish.

Ordering compacted volume. Order for the loose depth, about a third more.

Typical densities for gravel and crushed stone
Materiallb / ft³tons / yd³Sold byTypical use
Pea gravel (3/8″, rounded)100–1051.35ton or yd³Paths, patios, dog runs, drainage
#57 crushed stone (3/4″, washed)100–1051.35tonDrainage, slab sub-base, French drains
3/4″ minus / dense-grade105–1151.45tonDriveway base, paver base, road pack
Crushed concrete (RCA)100–1101.35tonDriveway base, structural fill (cheaper)
River rock (1–3″)95–1051.40ton or yd³Dry creek beds, borders, xeriscape
Decomposed granite110–1201.50tonPaths, patios, natural-look driveways
Road base / Class 5110–1201.50tonCompacted base under pavers, slabs, drives

Every material calculator

Each of these uses the same measured-drawing tool with the right density and bag sizes built in: gravel calculator , mulch calculator , concrete calculator , concrete slab calculator , sand calculator , topsoil calculator , paver sand calculator , crushed stone calculator , sonotube concrete calculator , pea gravel calculator , river rock calculator , decomposed granite calculator . Or start from the material calculator homepage and pick a material there.

Frequently asked questions

How much crushed concrete do I need?

Multiply area by depth in the same unit, divide by 27 for cubic yards, then multiply by about 1.35 for tons. A 500 square foot driveway at 4 inches needs roughly 10 to 11 tons.

How many tons of crushed concrete in a cubic yard?

About 1.35 tons, similar to natural crushed stone.

Is crushed concrete cheaper than gravel?

Usually 20 to 40% cheaper than virgin crushed stone, because it is a recycled product. Availability depends on having a crushing operation nearby.

Is crushed concrete good for a driveway?

Yes — the cement fines re-bind when compacted and wetted, giving a harder surface than natural stone of the same gradation. Grade it to shed water.

How deep should crushed concrete be for a driveway?

Four inches compacted over a firm sub-grade for cars, six inches where trucks drive, placed in 2-inch lifts.

Does crushed concrete have rebar in it?

Reputable suppliers screen and magnet-separate steel during crushing, but occasional wire flecks turn up. Ask for screened material if it is going under a slab or barefoot area.

How much area does a ton of crushed concrete cover?

About 90 square feet at 2 inches compacted, 60 at 3 inches, and 45 at 4 inches.

Can crushed concrete be used as a base under pavers?

Yes, a 3/4-inch-minus dense grade compacts to an excellent paver base. Use 4 inches for walkways and 6 inches for driveways.

Is crushed concrete good for a driveway?

Yes — the cement fines re-bind when compacted and wetted, so a 3/4-inch-minus RCA driveway sets up firmer than the same gradation of natural stone.

How much does crushed concrete cost compared to gravel?

Usually 20 to 40% less than virgin crushed stone, where a crushing operation is nearby to supply it.

Can crushed concrete be used as a paver base?

Yes, a dense-graded 3/4-inch-minus RCA compacts to an excellent base — 4 inches for walkways, 6 inches for driveways.

Does crushed concrete have rebar in it?

Processing removes almost all steel, but occasional wire flecks appear. Ask for screened material for slab bases and play areas.

How many tons of crushed concrete in a cubic yard?

About 1.35 tons, similar to natural crushed stone.